Description

Basic Electronics Circuit Trainer

Technical Specification :

DC POWER SUPPLY
Fixed DC power supply:
Voltage range: +-5V,+-12V
Max. Current output:0.3A
With output over-load protection
Dual DC power supply:
Voltage range:+-3V to +/-18V, continuously adjustable
Max. Current output: 1A
With output over-load protection
AC POWER SUPPLY
Voltage range: 9V to 0V , 9V
Max. Current output: 500 m A
With output over-load protection
SINGAL GENERATOR
Pulse generator: (TTL level)
Frequency range: 1Hz to10KHz 4settings, continuously adjustable
Fan out: 10 TTL load
Pulses witches:
2 independent output, TTL level
With Q, Q output, pulse width gerter 5ms
Fan out: 10 TTL load
Data switches
8 sets independent control output, TTL level with De-bounce circuit.
Fan out: 10 TTL load
FUNCTION GENERATOR
Output waveform: Sine, triangle, square
Output frequency: 10 to100KHz/4 settings, continuously adjustable
Output amplitude: 18Vpp (open circuit) 9Vpp (50 O load)
TESTING AND DISPLAY
3 1 div2 digital voltmeter/ammeter
DC voltage range: 2V,200V
DC voltage accuracy: +/-(0. percentage of reading +1digit)

c. DC current range: 200
Galvanometer
a. Current range50mA
b. Accuracy Class 2.5
LED indicator
a. 10 sets independent LED indicates high, low logic state
b. Input impedance: ≥100KΩ
Digital display
a. 2 sets independent 7-segment LED
b. WithBCD-7segment decoder/driver and DP Input
c. Input with 8-4-2-1 code
Breadboard: 1680 tie-point breadboard on top panel can be easily put
into and taken off
List of Module:
Basic Device Module
Basic Electricity Experiment Module
Sensor Module(1)
Sensor Module(2)
Diode, Clipper and Clamper Module
Rectifier, Differentiator Integrator Circuit Module
Transistor Amplifier Circuit Module
Multi-Stage Amplifier Circuit Module
FET Circuit Experiment Module
OP Amplifier Circuit Module 1, 2,3, 4, 5
Combination Logic Circuit Experiment Module 1, 2, 3, 4, 5
Sequential Logic Circuit Experiment Module 1, 2
System Transformer ( star delta )
List of Experiment:
Basic Measurement:
Resistance Measurements
Potentiometer characteristics
DC Voltage measurement

DC current Measurement
Ohm’s law application
AC voltage measurement
AC current measurement DC Circuits
Series-parallel network and kirchhoff’s law
Wheatstone bridge
Superposition, thevenin’s and norton’stheorems
Power in DC circuit
Maximum power transfer theorem
DC RC circuit and transient phenomena
DC RL circuit andtransient phenomena .AC Circuits
AC RC circuit – AC RL circuit .
AC RLC circuit – Series-resonant circuit
Parallel-resonant circuit
Power in AC circuit
Control Circuits
Water Level Control
Metal Detector
LightController Diode Characteristics
PN-junction diodeCharacteristics
Zener diode Characteristics
LED Characteristics-Photodiode
Characteristics Rectifiers and Filters-Half-wave rectifier
Full-wave rectifier-Bridge rectifier Dual-power rectifier
Voltage doubler Diode Clipping and Clamping Circuits
Clipping circuits
Clampping circuits Differentiator and Integrator -RC circuit
Differentiator circuit
Integrator circuit
RL circuit Transistor Characteristics
Basictransistor Characteristics
Transistor Cha racteristic

scurvesMultistage Amplifiers
RC-coupled
Direct-coupled amplifier
Transistor-coupled amplifier
Dual-end push-pull amplifierFET Characteristics
JFET Characteristic s
MOSFET Characteristic FET Amplifiers
JFETCS amplifier
JFET CD amplifier
MOSFET CS amplifier
OP AMP Characteristics differential amplifier in OP AMP
OP AMP Characteristics measurements Basic OP AMP Circuits
Inverting amplifier
Non inverting amplifier.
Voltage follower.
Differential amplifier.
Adder Clipping circuit.
Constant voltage circuit
Constant current circuit.
Differentiator -Integrator
Instrumentation amplifier.
OP AMP Applications
Active high-pass filter.
Active low-pass filter
Active band-pass filter
Tone control circuit OP AMP Comparators and Oscillators
Comparators
Schmitt trigger
Window comparator,
Monostable multi vibrator.
As table multi vibrator.

Sine wave oscillator.
Crystal oscillator….
Logic gate circuit
TTL circuit
CMOS circuit Threshold voltage measurement
Measuring TTL threshold voltage.
Measuring CMOS threshold voltage.
Voltage/current measurement
Measuring TTL I/O voltage and current.
Measuring CMOS voltage and current.

Accessories : 
Standard accessories.
User manual: 1 Nos.
Connecting Wire: 1 set

Others :
Origin Parts : China, Taiwan, Japan.
Manufacturing in Bangladesh.
Warranty: 01 year.
Installation, Testing.
Training.